Jumpking OR1213 Manual do Utilizador

YJ USA Corp., 3970 Lindbergh Drive Adison, TX 75001 www.jumppod.com877-928-8777WARNING

the sharplyspot.

14

151. Make sure you understand the information inthe box at the top of this page before youbegin assembling the trampoline.Lay three Top Tubes (1), (2)

16３FrameHolesV-rings810101010Springs (10)22Hook the V-ringV-ring81010FrameBlack webbing with yellow lineNo yellow line3. Lay the Bed (8) on the ground

1744. Lay the Frame Pad (9) on the frame. Do not use the trampoline without the Frame Pad (9), which is designed to reduce the likelihood of injury to

6. Using the included plastic tie, attach the SafetyPlacard (11) to the frame near the point wherejumpers will climb onto and off the trampoline.The t

10. Attach the other three Pole(16,17) in the same way. See inset drawing.1019１６１７１１11. Lay out Top G3 Pole (18), joint each section Connec

Attach the first hanging point at the upper edge of the Netting (20) with the G3 Pole (18) to the Hemisphere Cap (19) of Top enclosure po

15. Using the included plastic tie,attach the Safety Placard(10)to the Netting(20) near the door as shown. The trampoline/enclosure is now f

22It is possible forthe trampoline/enclosurebe blown about by high wind. Ifyou anticipatehigh winds, the trampoline/enclosure should bemoved to a shel

1 4 Top Tube(With T-connector, A marking)2 4 Top Tube(With Socket, B marking)3 4 Top Tube(With T-connector, C marking) 4 8 T-Connector 5 8 Leg Extensi

3

3. Place the trampoline and trampoline enclosure on a level surface before use.4. Must place the trampoline on lawn, bark wood chip, sa

525. Do not attach anything to the barrier that is not a manufacturer approved accessory or part of the enclosure system.26. Wear clothing

6Note: The